How to use the 12 Gauge bore sight?

12GA

Specification

ength:60mm; Tail width:22mm; Head width: 20mm

Laser Wave length (nm:) 640 to 660

ED Type: visible red laser

Power:<5 mW

Construction: Brass

Align Range: 15 to 100 yards

Dot Size:2 inches at 100 yards

Operation: On/Off End Cap

Temperature: -10'C to 40'C

Battery Type:3 X AG13 (Included)


  1. Unscrew the back cap from the bore sight by turning counterclockwise

  2. Stand the bore sight on a flat surface with the laser side pointing down

  3. Insert batteries (+ side up) inside the rear opening

  4. Carefully push down and turn the screw cap clockwise to tighten the cap (the laser is now on)

  5. Place in your rifle’s chamber and close the bolt

  6. To remove - open the bolt if it does not automatically extract, manually remove the unit by tilting the barrel upward (always practicing safe firearm practices)

  7. Unscrew the back and remove the batteries to turn the unit off

Share:

CONTACT US

Please contact with us for getting more information about our products and service.

  • *We respect your privacy. When you submit your contact information, we agree to only contact you in accordance with our Privacy Policy.

×

Contact Us

*We respect your privacy. When you submit your contact information, we agree to only contact you in accordance with our Privacy Policy.

×

Inquire

*Name
*Email
Company Name
Tel
*Message

*We respect your privacy. When you submit your contact information, we agree to only contact you in accordance with our Privacy Policy.